My Binding GBC STL1000 Instruction Manual download pdf (Page 25)

make it easier to load the book. Tighten the two adjusting knobs to secure the wire holder. Load book

onto element and adjust rear rail in the book loading area. To adjust, loosen adjusting screws and slide

up to book loosely.

Tighten adjusting screws.

11. Book Transport Area

At this time, check to see if the pusher will hit the rear rail or be pushed down because of rear rail

interference (see figure 11-1). To prevent the interference, push the pusher foot down below the table

top and tighten the set screw located on the top of the pusher foot (see figure 11-2) to lock in place.

Note: If you lock down one of the pusher feet, you must lock down the foot directly in front of it or it

will crash into the closing rail.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 42 43

No comments

My Binding GBC STL1000 Instruction Manual Page 25